| Management number | 238458166 | Release Date | 2026/07/11 | List Price | US$25.53 | Model Number | 238458166 | ||
|---|---|---|---|---|---|---|---|---|---|
| Category | |||||||||
<p>Description:</p> <p>Type:A/C compressor with clutch</p> <p>Direct Replacement</p> <p>Interchange Part Number:CO 11155C,92600CJ60A,92600CJ60B,92600CJ60C,92600CJ61B</p> <p>Other Part Number:58887,6512702,5512702,7512702,255600,2021623</p> <p>Other Part Number2:140336NC ,C2137R, C2678, 20-21623-AM</p> <p> Fitment:</p> <p>2007-2010 Nissan Versa 1.8L</p> <p>2007-2015 Nissan Tiida 1.8L</p> <p> Package includes:</p> <p>A/C compressor with clutch</p> <p> Note:</p> <p>Each AC air compressor comes with about 80ML of Oil. You dont need to add oil additionally.</p> <p>This compressor comes pre-filled with the correct amount of oil. Thus, there is no need to add any additional oil to your system.</p> <p>Please add refrigerant to 70-80% without filling up.</p> <p>There may be noise if the refrigerant is added too much</p> <p> Installation Method</p> <p> Attention Please:</p> <p>Be sure to clean the air conditioning system before installation, otherwise it will cause compression broken.</p> <p>1. Remove compressor:</p> <p>Remove the A/C belt from the A/C compressor pulley. May involve loosening the belt tensioner (if equipped).</p> <p>2.receiver drier or accumulator, orifice tube or expansion valve.</p> <p>3.Disconnect the negative battery cable.</p> <p>4.Remove the bolt that secures refrigerant lines to the A/C compressor. Inspect A/C lines for any contamination such as metal or excessive dirt inside of them. If you find any</p> <p>contamination the system will need to be cleaned.Flush the condenser and evaporator using NON-OIL BASED A/C flush. On expansion valve systems. The valve must be removed before</p> <p>the evaporator can be flushed. Flushed condensers from outlet to inlet and evaporators from inlet to outlet. </p> <p>5.Drain all the oil from the new compressor ,if you compressor has a drain plug you will need to open it up and drain what oil is in there too.</p> <p>6.Install half oil charge into the compressor and the remainder throughout the system. Turn compressor shaft 8-10 full revolutions to insure front seal and other internal</p> <p>parts are lubricated.</p> <p>7.Install new receiver drier or accumulator and new orifice tube or expansion valve.</p> <p>8.Evacuate the A/C system for a minimum of one hour.</p> <p>9.After evacuation install half the refrigerant charge and let the system set for 1 minute. This will allow the refrigerant to pick up oil and spread more evenly throughout</p> <p>the system.</p> <p>10.Turn on the A/C system with the engine running and check to see if cold air is now coming out of the air duct.</p> <p>11.If the A/C system is functioning ,you may find that your electric radiator fan and compressor clutch will be cycling off and on depending on the outside air temperature.</p> <p>To confirm that this part fits your vehicle, enter your vehicle's Year, Make, Model, Trim and Engine in the Compatibility Table.</p>
If you notice any omissions or errors in the product information on this page, please use the correction request form below.
Correction Request Form